Thetford 19621 - Seal Replacement Package Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Thetford 19621 - Seal Replacement Package herunter. Thetford 19621 - Seal Replacement Package User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Rev. 01/22/08
Form #19639B
Seal Replacement Package
Part #19621
To Remove Toilet From Floor
1. Turn off RV water supply per RV Owner’s Manual.
2. Press both keypad buttons at the same time, twice, to open blade
and drain bowl of water.
3. Pry off Bolt Caps with Flat-blade screwdriver. Use wrench to
remove 1/2-inch Lag Screws.
4. Swivel Toilet to gain access to back.
5. Turn off RV’s power supply to the Toilet.
6. Disconnect Water Supply Line with Adjustable Wrench (Fig. A).
7. Disconnect Toilet’s 12-volt power hookup to RV.
8.
Place an old towel or soft cloth on work surface. Remove Toilet from oor
and place upside down on work surface.
9. Remove old Closet Flange Seal (may be found in toilet or in oor
at Closet Flange). Discard.
10. Cover Holding Tank opening to contain odor.
Tools needed
Flat-blade screwdriver • Pliers
Adjustable Wrench
DAP Dynaex Caulk or equivalent (available at most hardware
stores)
Note:
Read all instructions before beginning work.
You may not need to replace all the Seals in this package.
All replacements will require removing toilet from oor.
Use gloves when handling parts that may have come in contact
with waste.
To Remove Parts
1. Tap out 2 Mounting Bushings (Fig. B).
2. Remove Mounting Flange and Flange Seal.
3. High Prole models only: Remove Extension Tube. It may
be found connected to Mounting Flange or to the Mechanism.
Remove Tube Seal.
4.
if you need to replace the Blade Seal, remove 4 Mechanism Screws
without Washers (MS, Fig. C). If not, remove the three screws shown
with washers (no arrows).
5. Lift Mechanism Assembly off Seal. Pull out carefully through back
of toilet, just far enough to gain access to the seal(s) to be replaced.
(No need to disconnect/remove motor wiring, Overow Tube or
Sound Deadening Insulation – if present – from Mechanism.)
To Replace Blade Seal
1. Remove Blade Seal (may be attached to white Mechanism Plate).
Discard. Fit new seal in its place.
Replacement of Blade Seal, O Ring Seal and Hopper Seal
RV Toilet Service Parts
for
Aria Deluxe II
Power supply
connector
Water supply
hookup
Fig. B
Mounting Bushing
White Mechanism Plate
Mechanism
Mounting Flange
Fig. C
Fig. A
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Aria Deluxe II

Rev. 01/22/08Form #19639BSeal Replacement PackagePart #19621To Remove Toilet From Floor1. Turn off RV water supply per RV Owner’s Manual.2. Press bo

Seite 2 - Part #19621

Part #19621 Seal Replacement Package Page 2Fig. EPinion GearGear/clutch as-semblyTo Replace O-Ring SealIf you do not need to replace this seal, sk

Seite 3

Replacing Flush Nozzle Seals This does not require removing the Mechanism. To Remove Old Parts1. Disconnect 2 upper Tubes from outside Nozzle Connect

Seite 4

Fig. KNozzle ConnectorLocking NutNozzle As-semblyGasketFoam Nozzle SealNozzle Con-nectorNozzleBack wall of china bowl5. Holding Hinge Post Nuts from

Kommentare zu diesen Handbüchern

Keine Kommentare