WARNING: Improper installation, adjustment, alteration, service or maintenancecan cause injury or property damage. Refer to this manual. For assis-
Installation Manual 10Offset vertical enclosures:If the enclosure depth is 24 inches or more and less than 25 inches (See Art01783):- Install an angl
Installation Manual 11If the enclosure depth is 26 inches or more (See Art01785):- Install an angled top baffle [172] between the top rear edge of th
Installation Manual 12If the design of the vehicle does not allow you to install a roof exhaust vent, install an upper side-wall exhaust vent.NOTE: T
Installation Manual 13- Make sure that the bend of the condenser baffle is flushwith the bottom edge of the door frame of the upperside-wall exhaust
Installation Manual 14NOTE: The doors are made to accept decorative panels. The decorative panels must be3/16 inch or less in thickness. Install th
Installation Manual 15When manually (by hand) or mechanically (by hoist , lift truck, etc.) handling arefrigerator that is not installed in an enclosu
Installation Manual 162. Make sure that the side trim pieces [127] are in thecorrect position (See Art01649 and Art01650):- Slide both side trim pie
Installation Manual 17This refrigerator operates on these electrical sources. Operation out of these limits may damage the refrigerator’s electrical
Installation Manual 18Connect the Propane Gas ComponentsThis refrigerator operates on propane gas at a pressure of 11 inches Water Column Propane.The
Installation Manual 19Connect the Ice Maker (optional)The ice maker is assembled to the refrigerators at the factory as optional equipment. If the re
Installation Manual 2Table of ContentsSafety AwarenessSafety Awareness ...
Installation Manual 20Ignition and Start UpBefore ignition or start up of the refrigerator:- Make sure the air flow in the lower intake vent, through
Installation Manual 21- If a less efficient energy source is not available:- An audible alarm starts.- A fault code shows in the center display.-
Installation Manual 22Fault CodessedoCtluaFgninaeMedoCtluaFsnoitcAevitcerroCoN.yalpsidsiegatlovCDehtotelbaliavanulortnocrotaregirferehtrolenap.FFOsiro
Installation Manual 3Certification and Code RequirementsSafety InstructionsWARNING:- This refrigerator is not approved for use as a free standing ref
Installation Manual 4Ventilation RequirementsWARNING: The completed installation must:- Make sure there is sufficient intake of fresh air for combus
Installation Manual 5Key Refrigerator DimensionsThese key refrigerator dimensions are for your reference as necessary (See Art01734).Refrigerator cabi
Installation Manual 6Assemble the Enclosure for the Refrigerator1. Make sure the enclosure shelf is solid and level. The enclosure shelf must be:-
Installation Manual 7You can change enclosures that were made for Norcold model N8XX refrigerators so that you can put Norcold model 121X refrigera-to
Installation Manual 81. Install the upper roof exhaust vent.CAUTION: Make sure that no sawdust, insulation, or other construction debris ison the re
Installation Manual 9If the enclosure depth is 25 inches or more and less than 26 inches (See Art01781):- Install a top baffle [13].- Make sure that
Kommentare zu diesen Handbüchern